In Oxyfuel cutting fuel gases and oxygen are used to cut sheet steel. Oxy-fuel cutting is a chemical reaction between pure oxygen and steel to form iron oxide. Preheat flames are used to raise the surface or edge of the steel to approximately 1800°F (bright red color).
In Oxyfuel cutting fuel gases and oxygen are used to cut sheet steel. Oxyfuel cutting is a chemical reaction between pure oxygen and steel to form iron oxide. Preheat flames are used to raise the surface or edge of the steel to approximately 1800°F (bright red color). Pure oxygen is then directed toward the heated area in a fine, high pressure stream. As the steel is oxidized and blown away to form a cavity, the preheat and oxygen stream are moved at constant speed to form a continuous cut. Only metals whose oxides have a lower melting point than the base metal itself can be cut with this process. Hence, Only low carbon steel and some low alloys meet the above condition and can be cut effectively with the oxyfuel process. IT can be best used for thickness of around 40 mm.
Oxyfuel cutting provides best results in square top corner (with minimum radius). It can cut face flat top to bottom (no undercut). It can cut face square with respect to top surface. Provides clean smooth surface with near vertical drag lines and little to no slag on bottom edge (easily removed by scraping).
We have oxyfuel Cutting machines with bed size of 2.8 x 6 mtrs & 6.5 x 16 mtrs. These machines are used in medium thickness sheet steel fabrications.
Heavy-duty production tool with cost-reducing Long Life technology for dramatically longer consumable life and much lower operating costs. Plasma will cut any electrically conductive metal....so stainless, aluminum and steel all cut quite well. Ideal for production environments cutting mild steel, stainless and aluminum up to 75 mm (3") thick.
Plasma cutting provides an optimal mix of cut quality, productivity and operating cost for mild steel, stainless and aluminum across a wide range of thickness at a competitive capital equipment price. Plasma does an excellent job on gauge materials, with very precise cut quality and virtually no material warpage.
We have bed plasma cutting machines of German make, Messer , with bed size of 2.8 x 6.5 mtrs & 6.5 x 16 mtrs. These machines are used mainly in heavy thickness sheet steel fabrications.